Do Not Attempt Black Mold Removal Before Reading This Article

When you discover that you have a mold problem, the best plan of action involves attacking the problem sooner instead of later. Due to the toxicity of black mold, it is imperative that you devise a good plan of attack that will both remove the mold in addition as prevent it from returning. The first step in your mold removal journey should start by arming yourself with the right tools and equipment to get the job done right the first time.

The main necessities required are listed below:

1. Long length rubber gloves to protect your hands.

2. Safety goggles that have no air venting or holes around the perimeter.

3. An approved confront disguise a 3M-N-95 will be sufficient.

4. Old clothing that is disposable or a white Tyvek suit to protect your body from the mold.

5. Mold cleaning products that are freely obtainable at the local hardware store.

Once you have gathered all of your personal protective equipment (PPE), you can begin the task of building an attack plan against this mold infestation you have.

In the first step you will need to locate exactly where the moisture is coming from that is feeding the mold. A few of the first places to look would include: 1. Bathroom walls and ceilings 2. Under sinks and around toilet bases 3. Any other areas where there is the possibility of water leakage inside the walls. 4. Highly humid areas such as laundry rooms, and unventilated bathrooms.

Once you have located the source of the mold and repaired any leaking water supplies that were feeding the problem, next is the removal course of action. You will want to begin by sealing off the affected area from the rest of the home to keep the airborne spores contained to just the room you are working in. Plastic sheeting secured to the ceilings and walls with duct or painters tape will help to contain the mess.

When everything is sealed appropriately you can begin the cleaning course of action. Many times if the mold problem is tiny you can simply use hot soapy water and a scrub brush to get it done. The main thing to be sure of is to remove all of the liquefied scrubbed mold mess that you end up with. Be sure to blot up all moldy liquid so there is no more visible to the naked eye.

Once you have finished wiping up the black mold, you must take great care to dispose of all of the towels, scrub brushes and any other tools or clothing used in the remediation course of action. The toxins that will be left on these items can easily start a new colony of Black Mold if left on premises. Seal them all up inside a double inner of plastic sheeting.

Once you have finished wiping up the black mold it is crucial that you get rid of the towels, sponges, and clothes that you used to accomplish this, as these are very toxic

After the initial disposal of the affected materials and or tools clothing you will need to do a second cleaning with a stronger chemical. Some say to use bleach and water, while others use the tried and true method of spraying white vinegar directly on the areas and allow to dry overnight. The vinegar will have a strong odor but is much less detrimental to your health than the bleach concoction.

Once you are finished applying this cleaner you then need to allow the area to dry, and once this has occurred you should then discard all of the disposable safety gear you used, in addition as any leftover cleaning supplies.

After the vinegar solution has been left to dry for 24 hours you should dispose of any other utensils used in the remediation course of action and all should be well again. Simply remove your obstacle that you erected prior to remediation (dispose of it in addition).

Leave a Reply